Chisel Interview Questions, Process, and Tips

Ques:- Every day a cyclist meets a train at a particular crossing .The road is straight before the crossing and both are travelling in the same direction.Cyclist travels with a speed of 10 kmph.One day the cyclist come late by 25 minutes and meets the train 5 km before the crossing.What is the speed of the train?
Ques:- The temperature of Chennai follows the equation t2/6+4t+12 where t is measured by the number of hours after midnight. Find out the percentage increase (or decrease) of temperature between 4pm and 9 pm of any day at Chennai.
Ques:- What was the percentage of money circulation in terms of 500 and 1000 Rupee note in India before 8th November?
Ques:- if a car starts from A towards B with some velocity due to some problem in the engine afetr travelling 30 km .if the car goes 4/5 th of its of actual velociteythe car reaches B 45 min later to the actual time.if the car engine fails after travelling 45km the car reaches the destination B 36min late to the actual time ,wat is the initial velocity of car and what is the distance between A and B on km.
Recent Answer : Added by Admin On 2020-05-17 12:04:29:

20&130

Ques:- In a can, there is a mixture of milk and water in the ratio 4 : 5. If it is filled with an additional 8 litres of milk the can would be full and ratio of milk and water would become 6 : 5. Find the capacity of the can?
Recent Answer : Added by N DHANAVEENA On 2021-10-19 17:55:00:

Ans-44
4x+8=6Y
5X=5Y
X=Y
FROM EQ 1
2X=8
X=4
6Y+5Y=11*4=44

Ques:- . Who was the Chairman of drafting Committee to prepare adraft Constitution for India?(1) Dr. S. Radha Krishnan(2) Dr. B.R. Ambedkar(3) K.M. Munshi(4) B.N. Roy
Ques:- How long will you continue with this job?
Ques:- A 6 inch length cylindrical through hole is drilled through the center of sphere, what will be the remaining volume of sphere ?

In this question only one data is given ie., hole length - 6". In the question there is no mistake.
Find the answer.
Recent Answer : Added by Admin On 2020-05-17 12:05:14:

volume of a sphere is 4/3 * pi * r^3
by drilling a hole 6 inches long the volume of the sphere is
not affected bcos the hole is a 1 dimension quantity..(say a
straight line) n so it does not have any value w.r.t volume…
hence the volume of the sphere does not change..

Ques:- A 4 digit no may consist of the digits 6,2,7,5 where none of the nos are repeated.Find the possible no of combinations divisible by 36?
Recent Answer : Added by Admin On 2020-05-17 12:02:15:

no combinations is there because a number divisible by 36
also divisible by its divisors anu.sum of 4 digits=20,whis
is not multiple of 3.so it is cannot divisible by 3

Ques:- 55*55*55+45*45*45/55*55-55*45+45*45
Recent Answer : Added by Admin On 2020-05-17 12:02:28:

100

Ques:- Why do you think that we will appoint you?
Ques:- Side of rhombus is 5cm and sum of lengths of diagonals is 12cm. what is the area of rhombus?
Ques:- There are 1997 doors in a auditorium and as many as people as the no of doors open enter the auditorium .A door was closed and as many as people as no of doors open leave the auditorium . the process was repeated till the no of doors is equal to1.find the total no of peoples enter the auditorium?
Recent Answer : Added by Admin On 2020-05-17 12:02:12:

1997

Ques:- Personal Experience
Ques:- A>B, B>C, C=D, D>E, then which is greatest
Recent Answer : Added by Admin On 2020-05-17 12:00:05:

Example 1:
Assign, A=20, B=10, C=5, D=5(Because C is equal to D as
given), E=1.
A/B = 20/10 = 2. So A/B = 2
A/C = 20/5 = 4. So A/C = 4
A/E = 20/1 = 20. So A/E = 20
Therefore “A/E is Greatest”
Example 2:
Assign, A=100, B=50, C=20, D=20(Because C is equal to D as
given), E=10.
A/B = 100/50 = 2. So A/B = 2
A/C = 100/20 = 5. So A/C = 5
A/E = 100/10 = 10. So A/E = 10
Therefore “A/E is Greatest”

Ques:- A die is rolled several times and the number appearing is summed. We stop when this sum becomes greater than or equal to 100. What value of sum in the end is the most probable (out of 100, 101, 102, 103, 104, 105)
Ques:- Eight persons – P, Q, R, S, T, U, V and W are sitting around a circular table. S is to the immediate right of W. V is not next to either R or T. W is to the immediate right of T, who is sitting opposite to R. U and W are sitting opposite to each other. If R and V interchange their places, then who is opposite T?
Ques:- What values do you consider important for professional success
Ques:- Describe your involvement in re engineering down-sizing or cost containment processes?
Ques:- If Rs.7500 are borrowed at C.I at the rate of 4% per annum, then after 2 years the amount to be paid is?
Ques:- You r given a thermometer. What can u do by this without measuring the temperature?
Ques:- I don’t know
Ques:- The time taken by a train 180 m long, travelling at 42 kmph, in pasing a person walking in the same direction at 6 kmph, will be
A. 16 sec
B. 18 sec
C. 21 sec
D. 24 sec
Recent Answer : Added by SHOWMINI R On 2022-08-14 16:29:07:

D = 180m
S = 42 – 6 = 36 * 5/18 = 10
T = D/S = 180/10
T = 18s

Ques:- Why are you willing to leave your current organization?
Ques:- What are the dimensions of the standard brick?
Ques:- Why are you interested in oour compnay ?
Ques:- What is the missing number in 56 / 7 = ? – 5
Recent Answer : Added by Hakeem Nazia Begum On 2022-09-22 16:40:09:

13

Ques:- What was the best achievement you had so far?
Ques:- A cistern is filled by a tap in 3 1/2 hours. Due to leak in the bottom of the cistern, it takes half an hour longer to fill the cistern. If the cistern is full how long will it take the leak to empty it?
Ques:- What was your toughest decision in your life?
Recent Answer : Added by DK BOSS On 2021-07-21 15:26:22:

choosing my career path

Contact with us regarding this list

Devendra Bhardwaj With a decade of experience as a Job Hiring Expert, I am a results-driven professional dedicated to elevating recruitment strategies. My expertise lies in navigating the dynamic landscape of talent acquisition, employing innovative approaches to attract, assess, and secure top-tier candidates. I excel in optimizing hiring processes, leveraging cutting-edge technologies, and fostering collaborative relationships with stakeholders. A keen understanding of industry trends allows me to stay ahead, ensuring a competitive edge in securing the best talent for your organization. I am passionate about connecting the right people with the right opportunities and thrive in creating impactful, streamlined recruitment solutions.

Scroll to top